Having an indicator to show the charge level of the battery has been a boon. However, its location is not very convenient. In order to charge the battery I had to open the hatch and keep it from closing while the charger was plugged in. It was not easy to position the charger.
Another trip to Battery World at Phillip to pick up a CTEK COMFORT INDICATOR PANEL M8. I chose the model with the 3.3m leads so that I could fit it into the dashboard near the steering wheel. Convenient to see the charge level and convenient to plug in the charger.
The battery is on the right rear behind the back wheel. So it was a straight and fairly easy run along the sill to the dash. Using my Kinchrome Panel Removal levers I popped off the plastic sill covers; from the front, the driver’s side kick panel (held to the firewall with a plastic nut), the front and rear sills and the B pillar cover. I lifted the panel that includes the HV battery vent, but I didn’t have to remove it; it was sufficient to see where the metal clip for the rear seat was.
Note: The B pillar cover is a bit tricky. Tip: Remove the cover from the seat belt bolt and then push the seat belt down until the bolt fitting is pointing to the floor. Then you can pull out the B pillar cover over the bolt.
The sills on the right hand side contain the 12 volt battery cables in one clip and the rear window washer fluid pipe in another. There’s enough room between those clips for the cable to sit snugly. The cable routing from the rear door sill to the battery takes some trial and error, but there is a safe path.
First problem – the panel
The panel is larger than the Toyota standard. There’s a 1.5 mm ridge around the opening and the CTEK panel would not fit. And I had to fit it first before I could run the cable.
There wasn’t much in it. I took a sharp hacksaw and cut into the corners. Then I cut away only the bottom and left ridges. This was enough to allow a tight fit and avoid more cuts that could have damaged wires behind the dash.
With a bit of fettling I found a cable path that was neat.
Second problem – not enough cable
Annoying. 3.3 m should have been plenty, but it was 10 cm short. No amount of fiddling would make it reach. I had an idea to retain the original cable intact and create 2 cables to join it to the battery. However, I didn’t want the fuse holder to be inaccessible under a panel.
So I spliced some heavy gauge wire into the cable. And then connected the eyelets to the battery terminals.
Replacing the panels was straightforward.
The Comfort Indicator Panel’s traffic light system differs slightly from the Comfort Indicator Eyelet as green is 100%-90%, yellow from 90%-40% and red for below 40% charge.
The beauty is that I can plug in the battery charger much easier.
Very convenient and easy to use and only slightly more effort than I had hoped.
And I still haven’t found (or looked for) the drain.